Office 17B, Sino Pak Plaza, College Road, Rawalpindi +92 321 2750276 ceo@nztech.com.pk

Electronics & Component-Level Repair

Embedded & Control Board Repair

Repair of microcontroller-based control boards used in machines, appliances-for-industry and custom automation.

Book This Repair
Microcontroller embedded control board undergoing component-level diagnosis and repair

What we repair

  • Microcontroller and processor boards
  • Relay and output driver sections
  • Input / sensor interface circuits
  • Communication sections (serial, RS-485, Ethernet)
  • Display and keypad interface boards

Common Faults We See

  • Controller dead or stuck in reset
  • Outputs not switching
  • Inputs not being read
  • Communication with other equipment lost
  • Board works sometimes, then freezes

How the Repair Is Handled

We work through power, clock, reset and signal paths logically, and replace failed interface and driver components so the board returns to reliable service.

  1. Book the job online and note your job number.
  2. Drop the equipment at our Rawalpindi workshop, or courier it to us.
  3. We diagnose the fault and share a quotation — confirmed at diagnosis, with no work done before your approval.
  4. After repair, the equipment is tested and quality-checked before you collect it or we courier it back.

You can follow every stage afterwards on the repair tracking page with your job number and phone number.

Book This Repair

Send in your equipment for diagnosis. The quotation is shared with you before any repair work starts — nothing is repaired without your approval.

Book a Repair Track an Existing Job

Prefer to talk first? Call +92 321 2750276 or message us on WhatsApp.

Embedded & Control Board Repair — Frequently Asked Questions

My control board works sometimes and then freezes. Can that be traced?

Intermittent faults are traced by working through the power, clock and reset sections and by heat/cool and signal checks while the board is running. Note when the freezing happens — it speeds up diagnosis.

The outputs on my controller no longer switch. Is that repairable?

Usually yes. Output driver and relay sections are common failure points and are repaired at component level, then every output is tested under load.

Can you repair boards with lost RS-485 or Ethernet communication?

Yes. Communication interface sections suffer most from surges and wiring faults. We repair the interface circuitry and verify communication on the bench before return.

More questions? See the full repair FAQ or contact the workshop.

WhatsApp Us